Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Grinder
•
Use the grinder to grind herbs, nuts and coff ee beans.
1.
Place the material in the bowl of the grinder. Fill half the space at most.
2. Place a sealing ring on the base of the grinder.
3.
Turn the base of the grinder upside down and with the blades turned
downward cover with it the bowl of the grinder.
4. Screw it on the bowl and tighten fi rmly by hand.
5.
Set the assembled grinder on the base with the motor and turn it to
secure it.
6. Switch to maximum speed or use the pulse mode.
7.
After grinding, you can change the base with blades for the lid with
chute and use it directly to sprinkle foods.
To ensure longevity of the appliance, do not let it run continuously for more than 3 minutes. Let it cool down
for 30 seconds prior to using it again.
The bowl of the mini food processor
1.
Attach the drive shaft to the base of the food processor and the work bowl.
2. Insert the bowl into the work bowl of the mini food processor. Make sure that the
ribs inside the hollow axis of the mini food processor fi t into the slots in the hollow
axis of the work bowl.
3.
Attach small chopper to the drive shaft.
4. Put in the material, which you want to process.
5.
Place the lid on, secure and switch on.
To ensure longevity of the appliance, do not let it run continuously for more than
30 seconds and always let the motor cool down for at least a minute after three cycles.
CLEANING
•
Prior to cleaning, switch the appliance off and unplug it.
•
Be very careful when handling the attachments and discs – they are very sharp and may cause injury.
•
Some foods may cause discoloration of plastics. This is entirely normal and it does not damage the
plastics or aff ect the taste of foods. To remove the discoloration and to clean the surfaces, which are in
contact with foods, wipe them with a cloth dipped in vegetable oil.
Cleaning the base: Clean the base using dry cloth.
Cleaning other parts of the food processor (except the base): Fill the sink halfway with water, put the
parts, which you want to clean in water and wipe the parts with sponge. Afterwards, dry the parts with dry
dish cloth.
GB
30°
90°
33
Tabla de contenido
