Erreka ROC Serie Manual De Instrucciones página 15

Adjusting the ends of stroke.
Once the motor has been installed on the blind, the power cable has been connected and the turn directions of the motor have been checked, pro-
ceed as follows:
1.- Release the end of stroke cover. Adjust the end of stroke of the closed blind (right) and position the end of stroke of the open blind of the micro
(left).
2.- Use the push-buttons to open the blind approximately 15 cm below the desired position and lower the blind once again. The wheel will have self-
adjusted to the open blind position.
3.- Close the blind. At the end of stroke, find the pin with two notches on the red washer and remove it.
4.- Check that the height adjustment is correct. If not, manually adjust the ends of stroke. Lastly, fix the protective cover in place.
Regulaciòn persiana cerrada
Adjusting closed blind
Adjusting open blind
Regulación persiana abierta
15