System Setup-Inactivity Standby; System Setup-Factory Defaults - Dish TR-40CRA Guía De Usuario

TR-40CRA D
System Setup—Inactivity Standby
Inactivity Standby automatically turns off your TR-40CRA converter when it has
not been used for a specified number of hours (default is four hours). It is
recommended to leave this setting on Enable, as it allows the receiver to
perform basic maintenance. Basic maintenance may delay or interrupt Inactivity
Standby. If Inactivity Standby is interrupted, the green light on the TR-40CRA
converter will be lit briefly.
To change or disable this feature, select Inactivity Standby from the System
Setup menu.
• Select Enable to turn this
feature on or Disable to turn
this feature off.
• Adjust how long your TR-
40CRA converter waits
before automatically turning
off by changing the setting
under Inactivity Duration.
System Setup—System
Information
The System Information screen
displays technical information
about your TR-40CRA converter.
To open the System Information
screen, select System
Information from the System
Setup menu, or press the SYS
INFO button on the TR-40CRA
remote control.
System Setup—Factory
Defaults
Use Factory Defaults to reset
your converter to its original
settings. Select Factory
Defaults from the System Setup
menu. A pop-up window appears—select Yes to reset to Factory Defaults.
Note: You will need to rescan your channels (see page 16) after resetting
factory defaults.
- -A
IGITAL TO
TV C
NALOG
Inactivity Standby
System Information Screen
Resetting Factory Defaults
ONVERTER
S S
YSTEM ETUP
Page 17