Trueshopping SFGT00B3SA Manual De Instrucciones página 13

INCREASING THE CUTTING LINE
1. Before starting ensure the cutting line is the correct length. Pull the cutting
line to the edge of the guard
2. During operation, to increase the length of the cutting line, stop and
re-start the trimmer line. Each time the trimmer is started and stopped
the line will feed out approx. 10mm.
USING THE PROTECTOR
The trimmer is fitted with a wire protector. To protect small plants etc.
from the rotating cutting line. The protector limits how close the head of
the trimmer can go to objects when the protector is in the lower position.
To use the protector fold it down so that its horizontal, this keeps the line a
safe distance from the end of the protector and helps prevent damage of
small plants and trees from the line.
Note: Always remove the battery pack from the trimmer before carrying
out any maintenance or making any adjustments to the line trimmer.
The trimmer is capable of performing light edging tasks.
CHANGING A LINE SPOOL
Note: Always remove the battery pack from the trimmer before carrying out any maintenance or making
any adjustments to the line trimmer.
1. Turn the line trimmer upside down so you have direct access to the spool.
2. Hold the bottom of the spool firm with one hand and with the other hand squeeze the tabs on either side
of the spool cover and remove the cover.
3. Remove the empty spool and clean out the spool cover.
4. Using a fully wound spool pass the line through the eyelet of the spool. Fit the spool of line into the
spool cover fully. Applying light pressure, rotate the spool of line until it locks in position.
5. Replace the spool cover ensuring the 2 clips locate and snap in place. Check the cover is secure.
6. Push the square button on the spool and at the same time, pull on the cutting line. Extend the line just
past the cutter on the guard.
CAUTION:
After changing the line spool, run the trimmer under no load for at least a minute to make sure
that the line and the tool are both operating correctly. Use only the line spool as recommended
by the manufacturer.
13