Maintenance And Repair; Technical Data - Kerbl FastHeat Instrucciones De Uso

4.4. Attention: only operate the device under supervision.
4.5. During longer warming periods please ensure that the liquid covers the heating ring at all times and the liquid level
does not sink. Never cover the device or the container.
4.6. When the red control lamp goes out this means the desired temperature has been reached. Turn the thermostat to
'minimum temperature' and pull the plug out of the socket. Leave the calf milk warmer in the liquid for a further
minute before removing it.
4.7. The heating element will still be hot after the plug is removed and must not be touched. Lay the calf milk warmer on
a non-flammable surface. Storage on a flammable surface (straw) is prohibited!
4.8. The calf's milk heater must be cleaned after every use. The heater
can be cleaned using a soft sponge cloth (do not use scrubbing
brushes, wire brushes, wire wool or other abrasive cleaning tools)
and lukewarm, soapy water. The calf's milk heater should be placed
in cold or warm water immediately after use. This makes the calf's
milk heater easier to clean and protects the PTFE coating. To clean
the handle and the stand pipe, use a soft, damp cloth that must be
completely free of solvents (acetone, petrol, alcohol or similar).

5. Maintenance and Repair

The device is maintenance free. The device must be taken out of opera-
tion immediately in the event of a defect. If repair is necessary please contact a specialist electrician or send the device to
the manufacturer for repair. A defective connection line may also only be repaired by the manufacturer or by a specialist
electrician in order to avoid hazard.

6. Technical Data (14150)

Power: 1700 W
Voltage: 230 V
Protection class: IPX 7
Weight: 2.8 kg
CE-conformity declaration
Albert KERBL GmbH hereby declares that the product / device described in these instructions complies with the fundamental
requirements and other relevant stipulations and regulations. The CE mark confirms compliance with the Directives of the European
Union.
Electronic scrap
Disposing of this device after its service life is the responsibility of the operator. Please consult the valid national regulations. The
device must not be disposed of in household waste. In accordance with the stipulations of the EU Directive on the Disposal of
Electrical and Electronic Devices, the device can be disposed of free of charge at the local waste collection or recycling centre. Alter-
natively, it can be returned to retailers who offer a collection service. The proper disposal helps to ensure environmental protection
and prevents any adverse effects on human health and the environment.
9