HQ-Power VDPDP136 Manual Del Usuario página 5

• Select a location where the device will be protected against extreme heat, moisture and dust.
• Do not use or transport the device under temperatures < 5°C or > 35°C.
• Familiarise yourself with the functions of the device before actually using it. Do not permit operation by unqualified
people. Any damage that may occur will probably be due to unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• Note that all modifications of the device are forbidden for safety reasons.
• Do not remove the serial number sticker from the device as doing so will void the warranty. Only use the device
for its intended purpose. All other uses may cause short circuits, burns, electroshocks, lamp explosions, crashes,
etc. Using the device in an unauthorised way will void the warranty.
4. Description
a) Top panel
1. ON/OFF button
2. Channel dimmer: to adjust the dimming level per channel
3. Channel dimmer indicators: shows the dimming level of the selected channel
4. Channel flash buttons: press these buttons to make an individual channel jump to 100% output
5. Mode indicators
6. Mode selection button (MODE SELECT): to switch between the various modes
7. LED display
8. Programme selection button (PROG SELECT): choose one of the 42 available chaser programmes
9. Fade time slider: adjusts the time between device activation and deactivation (not in "flash" and "full-on" mode).
10. Master fader + Master dimmer indicator
11. Audio level fader: to adjust the music sensitivity + Music level indicator
12. Speed fader: to adjust the chase speed + Chase speed indicator
13. Standby: to disable all outputs (chaser programme will continue to run but no output is generated)
14. Full on: sets the output of all channels to 100%. Release the button to return to the initial settings.
15. TAP SYNC: press this button twice to define the rhythm of the music and to make the chaser move to it.
16. Built-in microphone
b) Rear panel
17. Audio input: 100mV-1Vpp line in
18. Fuses (F6.3A 250V 5x20mm)
19. VDE socket outputs
20. AC power input
VDPDP136_v2
Fig. 2
5
Fig. 1
HQ POWER