Kenwood KSC-256 Manual De Instrucciones página 5

O
rientatiOn
Note: The battery slots are molded for different model types. The illustration shows the
KSC-256.
Power switch
Charging slot
Slide a battery pack
or a transceiver
equipped with a
battery pack into
this slot.
Tri-color indicator
Informs you of the current
charger status.
s
peciFicatiOns
AC Voltages
Dimensions (W x H x D) (charger only)
Weight (charger only)
ATTENTION: Check the rating label attached to the bottom of the charger for other important
specifications.
c t
harging ips
Using the transceiver while charging its battery pack will interfere with correct charging.
◆
If the operating time of a battery pack decreases although the battery pack is fully and
◆
correctly charged, the battery pack life is over. Replace the battery pack.
The ambient temperature should be from 0°C to 40°C while charging is in progress.
◆
When the ambient temperature is in the upper limits (close to 40°C), the charging time may
become longer than normal.
The charging times provided are obtained when a battery pack discharged to 1 V/cell x 6 (Ni-
◆
Cd and Ni-MH) or 3 V/cell x 2 (Li-ion) is charged at normal temperatures. This charging time
varies depending on the degree of discharge and the ambient charging temperature.
If the battery pack contacts are not properly mated with the charger terminals, the indicator
◆
may blink red or may remain unlit. To resolve this problem, reinsert the battery pack after
cleaning the battery pack contacts and the charger terminals.
Ni-Cd and Ni-MH Only: Repeatedly recharging a fully charged battery pack, or almost fully
◆
charged pack, shortens its operating time. To resolve this problem, use the pack until it is
completely discharged, 1 V/cell x 6 then recharge the pack to full capacity.
Ni-Cd and Ni-MH Only: The battery life in charge/discharge cycles is approximately 300.
◆
However, overcharging and excessive discharging shortens the battery pack life.
When using this equipment near a radio, transceiver or television, you may experience
◆
interference with reception.
AC inlet
Plug in the supplied AC cord here.
100 - 240 V AC
526 x 105 x 203 mm
20.7 x 4.1 x 8.0 inches
Approx. 3 kg / 106 oz
Nameplate location
Attach a nameplate sticker
in this location, showing the
model name, user name,
etc. for the charger slot.