Operation; Maintenance And Care - Aerial AD 110 Manual De Instrucciones

4. Make sure that the mains plug is
suitable for the socket of the
building.
5. Make sure that the socket used is
earthed.
6. Plug the mains plug into the socket.
9

Operation

Dehumidifying the room
NOTE: Allow the dehumidifier to rest in
its final position for approx. 15 minutes
before starting up, after transport and
after prolonged storage.
Procedure
1. Make sure that the condensate
water can drain off through a
discharge hose
Turn the humidity switch from "0" to
2.
"Cont". Set the desired humidity at
the humidity
dehumidifier will only start if the
actual room humidity is higher than
the target room humidity.
Light illuminates. The dehumidifier
will start operating. The dehumidifier
runs until the target room humidity has
been reached, then it will stop running. If
the humidity switch is at "Cont", the
dehumidifier will run continuously.
Switching off
Procedure
Set humidity switch to "0".
1.

10 Maintenance and care

WARNING! Damage to health from
dust!

Only clean the dehumidifier with
compressed air in open spaces.

Wear a protective
goggles.
WARNING! Risk of injury from
rotating fan.
Before opening the bezel:


CAUTION! Risk of burning from hot
cables!
Some cables inside the housing can get
hot and cause slight burns.

ATTENTION! Damage to property!


Cleaning and inspection
Procedure
1.
2.
switch. The
3.
4.
5.
6.
7.
8.
mask and
18
Disconnect the mains plug and wait
at least 15 s.
Make sure that the fan has stopped.
Allow the cables to cool down
sufficiently.
Cleaning agents
surfaces. Only use mild detergents.
Only use approved original spare
parts.
Switch off the dehumidifier.
Unplug the mains plug.
Remove and clean the air filter (e.g.
with vacuum cleaner) or replace it.
Check the discharge nozzle and
hose, if connected.
Insert a new or clean filter. Only use
an original filter.
Undo the screws on the side panels
and the lid and remove the bezel.
Undo the screws on the heat
exchanger cover and remove the
lid.
Pull out the drip tray slightly (Pos. 1)
and wipe with a cloth.
can damage