Safety Standards; Rating Plate - DAL DEGAN DL218 Manual De Uso

30
• Electric discharge:: on pump units with electric engine, make sure that the electric connection is compliant with
the standards applicable in the Country where you are using the pump unit and that the voltage corresponds
to the data displayed on the rating plate applied on the housing.
• Do not pass power cables for machine direction or tools, as they may irreparably damage the unit.
• Do not aim the spraying jet on the pump unit to avoid electric discharge.
• Make sure that the current voltage matches the one displayed on the plate of the pump unit.
• Check that the system features an earthing connection configured according to the standards applicable in the
Country where you are using the pump unit.
• Make sure that the current voltage matches the one displayed on the plate
of the pump unit.
• Check that the system features an earthing connection configured according to the standards applicable
in the Country where you are using the pump unit.
• Unplug the unit from its power supply before performing any type of task.
• Do not leave the pump unit exposed to weather agents (rainfall etc.).
• The power cable is not included. Contact an electric retailer to help you choose of the power cable, i.e. one with suit-
able cross-section and length (be sure to have the rating plate data at hand). The use of approved electric material
is compulsory.
• Do not alter engine rpm: if it is out of phase or poorly adjusted, have it checked by a service centre or authorised retailer.
• Always check the integrity of the electric cable before using the pump unit. In case of injury or wear, replace it.
• Do not lay the power cable on wet or muddy ground.
diaphrams pUmps

SAfETY STANDARDS

RATINg PLATE

DL 325 SC
motor SC.4t
220 Volt 380 Volt