Lamp (Re)Placement - JB Systems FALCON Manual De Instrucciones

ENGLISH
Some important instructions:
• To protect the environment, please try to recycle the packing material as much as
possible.
• Keep this booklet in a safe place for future consultation. If you sell the fixture, be
sure to add this user manual.
• To prevent fire or shock hazard, do not expose this appliance to rain or moisture.
• Don't place metal objects or spill liquid inside the unit. Electric shock or malfunction
may result. If a foreign object enters the unit, immediately disconnect the mains
power.
• Locate the fixture in a well ventilated spot, away from any flammable materials
and/or liquids. The fixture must be fixed at about 15cm from surrounding walls.
• Don't cover any ventilation openings as this may result in overheating.
• Prevent use in dusty environments and clean the unit regularly.
• The electrical installation should be carried out by qualified personal.
• This fixture must be earthed to in order comply with safety regulations.
• In order to prevent electric shock, do not open the cover. Apart from the lamp, there
are no user serviceable parts inside.
• In the event of serious operating problems, stop using the fixture and contact your
dealer immediately.

LAMP (RE)PLACEMENT

1. Switch off the unit and unplug the mains cable.
2. Wait until the unit has been cooled down.
3. Use a screwdriver to unscrew the 2 screws that close
lamp compartment on the upper side of the fixture. (see
photo)
4. On the inside you will see the lamp socket. Tear the lamp
socket gently out of the lamp compartment.
5. Unplug the old lamp. Hold the lamp socket while
unplugging the lamp instead of pulling the cable!
6. Hold the lamp socket while pressing the new ELC250
lamp gently in the socket.
Attention! Don't touch the bulb inside the lamp reflector
with bare hands! This will drastically shorten the lifespan
of the lamp. If you touched the lamp, clean it with a cloth
and a little denatured alcohol. Wipe the lamp off before
installing.
7. Put the installed lamp back inside the unit as shown on
the photo. Be sure that the wires don't touch the lamp
reflector.
8. Close the lamp compartment with the 2 screws. Done!
JB SYSTEMS 2/31
OPERATION MANUAL
FALCON