Mounting The Flexible Drive-Shaft Tube; Controls; Engine Start/Stop Switch; Throttle Control Lever - Alpina B 26 J Manual De Instrucciones

4.7 MOUNTING THE FLEXIBLE
DRIVE-SHAFT TUBE
1. Remove the protective cuffs (Fig. 13.A)
from both ends of the flexible drive
tube (Fig. 13.B), taking note that there
are differences between them.
2. Lift the pin (Fig. 14.A) and insert the
end with the hole (Fig. 14.B) in the seat
of the power unit (Fig. 14.C), ensuring
that the hole is turned upward.
3. Release the pin (Fig. 14.A), making
sure it is lowered completely to lock
the end of the tube (Fig. 14.D).
4. Remove the protection cap (Fig. 15.A)
from the tube (Fig. 15.B) protruding
from the rear handgrip (Fig. 15.C).
5. Insert the end with the groove (Fig. 15.D)
in the protruding tube of the rear handgrip
(Fig. 15.B) and fasten it with the screw
(Fig. 15.E) ensuring it stays locked.
6. Remove the air filter cover (par. 8.3).
7. Insert the register (Fig. 16.A)of the
throttle wire in the support slot and
connect the wire (Fig. 17.A) to the
carburettor lever (Fig. 17.B).
8. Work the nuts (Fig. 17.C) to tighten the
wire and block the register on the support.
9. Connect the two terminals of the
cables (Fig. 18.A) and (Fig. 18.B) to the
corresponding cables on the power unit.
10. Fit air filter cover.

5. CONTROLS

5.1 ENGINE START/STOP SWITCH

Used to start and stop the engine. The
switch has two positions (Fig. 18.A):
STOP - the engine stops and
cannot be restarted.
START - the engine can start and run.

5.2 THROTTLE CONTROL LEVER

Enables the speed of the cutting
means to be adjusted (Fig. 18.B).
The throttle control lever (Fig. 18.B) can
be used only if the throttle safety lever is
pushed at the same time (Fig. 18.C).
The correct running speed will be
achieved by pressing the throttle control
lever (Fig. 18.B) as far as possible.

5.3 THROTTLE SAFETY LEVER

The throttle safety lever (Fig. 18.C) enables
the throttle control lever (Fig. 18.B).
5.4 THROTTLE SHUTTER
BUTTON (OPTIONAL)
Used to turn on the engine
when cold (Fig. 18.D).

5.5 HANDLE FOR MANUAL START

Enables manual starting of the engine (Fig. 18.I).

5.6 CHOKE LEVER

Used to turn on the engine when cold. The
starter has two positions (Fig. 18.E):
position A - the choke is not engaged
(normal use and warm start)
position B - the choke is
engaged (for cold start)

5.7 PRIMER CONTROL BUTTON

Press the rubber button of the primer
to inject fuel into the carburettor intake
manifold to facilitate startup (Fig. 18.F).

6. USING THE MACHINE

IMPORTANT The safety regulations to
follow during machine use are described
in Chapter 2. Strictly comply with these
instructions to avoid serious risks or hazards.
IMPORTANT The machine
is supplied without fuel.

6.1 PREPARATION

Before using the machine:
1. place the machine in a stable
horizontal position on the ground;
2. choose the most suitable cutting means
for the job to be done (par. 4.3);
EN - 9