Installing The Video Splitter; Tools Required - Dometic PERFECTVIEW VS400 Instrucciones De Montaje Y De Uso

VS400
6

Installing the video splitter

6.1

Tools required

For installation and assembly, you will need the following tools:
• Drill bit set (fig. 4 1, page 4)
• Electric drill (fig. 4 2, page 4)
• Screwdriver (fig. 4 3, page 4)
• Set of ring or open-ended spanners (fig. 4 4, page 4)
• Measuring ruler (fig. 4 5, page 4)
• Hammer (fig. 4 6, page 4)
• Centre punch (fig. 4 7, page 4)
To establish and test the electrical connection, the following tools are required:
• Diode test lamp (fig. 4 8, page 4) or voltmeter (fig. 4 9, page 4)
• Crimping tool (fig. 4 10, page 4)
• Insulating tape (fig. 4 11, page 4)
• Cable bushing sleeves (optional)
To secure the controller and the cables, you may require additional screws and cable binders.
!
CAUTION!
Select the location of the modules so that they cannot injure the passengers in the vehi-
cle under any circumstances (e.g. sudden braking, road traffic accidents).
Observe the following installation instructions:
• The installation location must be protected from moisture and be inside the vehicle.
• The installation location should be level.
• Before drilling each hole, ensure there is sufficient space on the other side for the drill head to
emerge (fig. 5, page 5).
To perform the installation, proceed as follows:
➤ Attach the controller and the operating unit to their respective installation location
provisionally.
➤ Install the rear view video system if you have not already done so.
➤ Start up the rear view video system.
If transmission of the camera image is stable, you can carry out the final installation the control-
ler and operating unit.
EN
Installing the video splitter
13