Commissioning; Setting Up Liprotec System - Schluter Liprotec LT EBR 1 Manual De Uso

EN

Commissioning

If the cable is not sufficient for this, extend the

connection cable to a maximum of 2 m. To do this, use a
LIPROTEC LT ZK 2A cable and two LIPROTEC-ZKL
terminal connectors.
Then follow the instructions in the

for use
, chapter "Connection".
7 Commissioning

7.1 Setting up LIPROTEC system

To set up the LIPROTEC system, proceed as follows:
Make sure all components are correctly mounted and

connected as desired.
Switch on the mains power supply.

Make sure all LED strips light up.

Make sure the LIPROTEC system fundamentally works.

Connect all cable channels and cladding.

You can now test the control of the Bluetooth

receiver with the remote control and a mobile
device!
58
power pack directions
Bluetooth receiver directions for use