Additional Safety Rules - Makita 4014N Manual De Instrucciones

ENGLISH
1 Nozzle
2 Blower outlet
3 Suction inlet
4 Dust bag
5 Fastener
SPECIFICATIONS
Model
Capacities
Air pressure (water column) ...................................................... 560 mm
Air volume ................................................................................ 2.8 m
No load speed (min –1 ) ................................................................ 16,000
Overall length .............................................................................. 430 mm
Net weight ................................................................................... 1.75 kg
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Safety hints
For your own safety, please refer to the enclosed safety
instructions.

ADDITIONAL SAFETY RULES

1. Always use protective goggles, a cap and mask
when using the blower.
2. Never point the nozzle at anyone in the vicinity
when using the blower.
3. Always use the dust bag when collecting dust,
chips and the like.
4. Do not collect still smoldering cigarette ashes or
freshly cut metals shavings. Warning – Electric
shock could occur if used on wet surfaces. Do
not expose to rain. Store indoors.
5. Never block suction inlet and/or blower outlet.
Increased motor revolution may cause danger-
ous fan breakage.
SAVE THESE INSTRUCTIONS.
OPERATING INSTRUCTIONS
Blowing (Fig. 1)
For dust blowing, attach nozzle to blower outlet, turning
clockwise to lock it in place.
Dust suction (Fig. 2 & 3)
Note:
Dust bags are optional accessories in some countries.
For dust suction, fit nozzle onto suction inlet and dust
bag onto blower outlet.
After the bag fills with dust, empty the contents of the
dust bag into a dust bin by releasing the fastener.
4
Explanation of general view
6 Switch trigger
7 Lock button
8 Speed control screw
9 Lower
10 Higher
Switch action
CAUTION:
Before plugging in the tool, always check to see that the
switch trigger actuates properly and returns to the "OFF"
position when released.
For 4014N (Fig. 4)
To start the tool, simply pull the trigger. Release the trig-
ger to stop. For continuous operation, pull the trigger and
then push in the lock button. To stop the tool from the
locked position, pull the trigger fully, then release it.
For 4014NV (Fig. 5)
To start the tool, simply pull the trigger. Tool speed is
increased by increasing pressure on the trigger. Release
the trigger to stop. For continuous operation, pull the trig-
ger and then push in the lock button. To stop the tool from
the locked position, pull the trigger fully, then release it.
A speed control screw is provided so that maximum tool
speed can be limited (variable). Turn the speed control screw clockwise for higher speed, and counterclockwise
for lower speed.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Replacement of carbon brushes (Fig. 6 & 7)
Replace carbon brushes when they are worn down to the
limit mark. Both identical carbon brushes should be
replaced at the same time.
To maintain product safety and reliability, repairs, mainte-
nance or adjustment should be carried out by a Makita
Authorized Service Center.
11 Limit mark
12 Screwdriver
13 Brush holder cap
4014N
3
/min.
4014NV
0 – 560 mm
3
0 – 2.8 m /min.
0 – 16,000
430 mm
1.75 kg