Tabla de contenido
Idiomas disponibles
Idiomas disponibles
30" DUAL FUEL RANGE INSTALLATION INSTRUCTIONS
Important Safety Warning
To reduce the risk of tipping of the range, the range
must be secured to the floor by the properly installed
anti-tip bracket and screws packed with the range. These
parts are located in a plastic bag in the oven. Failure to
install the anti-tip bracket will allow the range to tip over
if excessive weight is placed on an open door or if a child
climbs upon it. Serious injury might result from spilled
hot liquids or from the range itself.
Follow the instructions below to install the anti-tip
bracket.
If range is ever moved to a different location, the anti-
tip bracket must also be moved and installed with the
range.
Tools Required:
5/16" (8 mm) Nut driver or Flat Head Screwdriver
Adjustable Wrench
Electric Drill
3/16" (4.8 mm) Diameter Drill Bit
3/16" (4.8 mm) Diameter Masonry Drill Bit (if installing in
concrete)
Anti-Tip Bracket Installation
1. The anti-tip bracket can be install on the right or left
side at back of the range.
2. The anti-tip bracket support is attached to the floor
at the back. When fastening to the floor, be sure
that screws do not penetrate electrical wiring or
plumbing. The screws provided will work in either
wood or concrete.
3. Unfold paper template and place it flat on the floor
with the back and side edges positioned exactly
where the back and sides of range will be located
when installed. (Use the diagram in figure 20 to
locate bracket if template is not available.)
2-1/2" typ.
11-5/16" typ.
C e n
t e r
Install the anti-tip bracket
on the right or left side
Figure 20
(Model with Electric Oven and Gas Cooktop)
l i n e
4. Mark on the floor the location of the 2 mounting
holes shown on the template (right or left position).
For easier installation, 3/16" (4.8 mm) diameter pilot
holes 1/2" (1.3 cm) deep can be drilled into the floor.
5. Remove template and place bracket on floor (see
figure 20). Line up holes in bracket with marks on
floor and attach the bracket using the 2 screws
provided. Bracket must be secured to solid floor. If
attaching to concrete floor, first drill 3/16" (4.8 mm)
dia. pilot holes using a masonry drill bit.
6. Level range if necessary, by adjusting the 4 leveling
legs with an adjustable wrench. Loosen the screw
which fixes the decorative leg and lift it to reach the
leveling leg. Turn the leveling leg counterclockwise to
raise the range or clockwise to lower the range (see
Figure 21).
7. Before sliding the range to its final position; take
note of the serial and model numbers for future
reference. Slide range into place making sure rear
leg is trapped by the bracket. Range may need to be
shifted slightly to one side as it is being pushed back
to allow rear leg to align with bracket.
8. After installation, visually verify that the anti-tip
bracket is engaged.
Leveling
Leg
Lower
11
Decorative
Leg Screw
Raise
Figure 21
Tabla de contenido
