Troubleshooting - Magic Vac P0211ED Instrucciones De Uso

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

MAGIC VAC ® does not work

• Check that the MAGIC VAC ® is plugged in. Check

the electrical outlet by trying another device in the

same outlet.

• Make sure the power cable and/or plug are not

defective. If so, do not use the machine.

MAGIC VAC ® does not perform the first seal on the

piece of cut roll

• Check that the piece of cut roll is correctly posi-

tioned as described in the paragraph: "Making bags

from MAGIC VAC ® rolls".

MAGIC VAC®does not completely vacuum-pack

the bags

• In order to correctly seal the bags, the open end

must be entirely inside the Vacuum Chamber.

• Make sure the Sealing Bar, the Airtight Gasket and

Sealing Gasket are not dirty. After cleaning, cor-

rectly replace them.

• The MAGIC VAC ® bag may be punctured. To check,

seal the bag with air inside, place it under water and

squeeze. If you see bubbles, there is a leak. Reseal or

use another bag.

MAGIC VAC® does not correctly seal the bag

• If the Sealing Bar overheats and melts the bag, lift

the Cover and allow the Sealing Bar to cool for a few

minutes.

The MAGIC VAC® doesn't maintain its vacuum

after sealing

• Leaks along the seal can be caused by wrinkles,

crumbs, grease or liquids. Open the bag, clean the

upper part of the inside of the bag and remove any

residue from the Sealing Bar before resealing.

• Make sure the bag is not punctured and thus did

not maintain the vacuum. Protect any pointed

edges of the contents in the bag using paper nap-

kins.

MAGIC VAC® does not seal containers

• Using the Connection Tube, connect the lid of the

canister (or Lid Attachment if necessary) with the

Air Intake on the machine.

• Leave adequate space (at least 3 cm) between the

contents and the top of the jar or canister.

• If liquids escape during the vacuum-packing

phase, remember that they must first be refriger-

ated and not at room temperature.

• Make sure that the rim of the jar or canister and

universal lid are not damaged in the sealing zone.

Clean the rim and the lid with a damp cloth and

reseal.

• Make sure the gasket on the canister lid or uni-

versal lid is placed in the correct position and not

damaged.

MAGIC VAC® Executive canisters or MAGIC VAC®

Universal Lids do not maintain their seal

• Make sure the knob on the canister lid is set to

"VACUUM" before vacuum-packing and that it is set

to "CLOSED" after it is complete.

• Check that the O-Ring under the knob on the canis-

ter lid or universal lid is correctly positioned.