Dea Digipro Instrucciones De Uso página 16

3.10 Admin code modification
In setting mode:
• Press followed by
times (the admin code length must be the same as above): the sound "BI" indicates that the
modification was successful.
• Press to exit the setting mode.
3.11 Turn on/turn off the anti-removal alarm
In setting mode:
• Press followed by
will be heard and the yellow LED remains fixed, the anti-removal alarm is turned off.
• Press followed by
will be heard and the yellow LED remains fixed, the anti-removal alarm is turned on.
• Press to exit the setting mode.
Warning: The built-in buzzer will continuously beep if the photoresistor is exposed to light. The
buzzer will automatically turn off within 60 seconds when the light is no longer detected, or by
entering the admin code.
3.12 Turn on/turn off the bell
In setting mode:
• Press followed by
will be heard and the yellow LED remains fixed, the bell is turned off.
• Press followed by
will be heard and the yellow LED remains fixed, the bell is turned on.
• Press to exit the setting mode.
Warning: The bell in ZONE 2 is available if the bell function is on. Press
relay will active once, activating the bell.
Warning: If the bell is enable in ZONE 2, you can't use cards or user codes.
3.13 Adding the master card (ZONE 1 only)
In setting mode:
• Press followed by
stored, otherwise, if the LED turns red it means there is already saved data, press the
twice to clear the memory, at this point the green LED blinks, then swipe the master card, a
long "beep" will be heard to indicate that the addition was successful.
• Press to exit the setting mode.
3.14 Enter settings mode swiping the master card
To enter the setting mode:
• Swipe the master card, the yellow LED blinks and a long "BI" will be heard as confirmation of
entry;
• To exit the setting mode, bring back the master card, the LED will turn green and you will hear
3 quick "BEEP" to confirm the exit.
Warning: The access control will be locked for 60 seconds after entering a wrong code or the
swiping an invalid card for 5 times (both the keyboard and the card recognition won't be available
during these 60 sec.).
14
, the yellow LED blinks, then insert a new administrator code two
(the yellow led blinks), then press
(the yellow led blinks), then press
(the yellow led blinks), then press
(the yellow led blinks), then press
, the green LED will blinks indicating that there are no master cards
followed by , a long "BEEP"
followed by , a long "BEEP"
followed by , a long "BEEP"
followed by , a long "BEEP"
in standby mode, the
key