Tabla de contenido
Idiomas disponibles
Idiomas disponibles
GAS COOKTOP INSTALLATION INSTRUCTIONS
Electrical Requirements
120 volt, 60 Hertz, properly grounded branch circuit
protected by a 15 amp circuit breaker or time delay fuse.
Do not use an extension cord with this cooktop.
Grounding Instructions
IMPORTANT Please read carefully.
For personal safety, this appliance must be properly
grounded.
The power cord of this appliance is equipped with a
3-prong (grounding) plug which mates with a standard
3-prong grounding wall receptacle (see Figure 7) to
minimize the possibility of electric shock hazard from the
appliance.
Preferred Method
Grounding type
wall receptacle
Figure 7
The wall receptacle and circuit should be checked by
a qualified electrician to make sure the receptacle is
properly grounded.
Where a standard 2-prong wall receptacle is installed,
it is the personal responsibility and obligation of the
consumer to have it replaced by a properly grounded
3-prong wall receptacle.
Do not, under any circumstances, cut or remove the
third (ground) prong from the power cord.
Disconnect electrical supply cord from
wall receptacle before servicing cooktop.
Check Operation
Refer to the Use and Care Guide packaged with the
cooktop for operating instructions and for care and
cleaning of your cooktop.
Do not touch the burners. They may be hot enough to
cause burns.
1.Install Burner Caps
Round Style Burners
This cooktop is equipped with sealed burners. All pieces
are at their place. Take note where they are. Remove
all packaging material. Make sure the burner caps are
(For 30" & 36" Models)
Do not, under any
circumstances, cut,
remove, or bypass
the grounding
prong.
Power supply cord with
3-prong grounding plug.
properly aligned and leveled. The burner cap lip (See Fig.
8) should fit snug into the center of burner head and
rest level. Refer to Figs. 9 & 10 for correct and incorrect
burner cap placement. Once in place, you may check the
fit by gently sliding the burner cap from side to side (Fig.
11) to be sure it is centered and firmly seated. When the
burner cap lip makes contact inside the center of the
burner head you will be able to feel it. Please note that
the burner cap should NOT move off the center of the
burner head when sliding from side to side. NOTE: There
are no burner adjustments necessary on this cooktop.
Burner Cap
Burner Head
Correct Burner Cap
Placement - Fig. 9
Fig. 11
Bridge Style Burners
Install Burner Caps, these include one Bridge Burner
Center Cap
(rectangular shaped)
and the two Bridge
Burner End Caps (The
Bridge Burner End
Caps will fit either
the front or rear
Bridge Burner Head
locations). Make sure
that the lips located
under the Bridge
Burner Caps fall into
the slots located in the
Bridge Burner Head
(See arrows in Figure
12) and that all the
Bridge Burner Caps lie
flat and evenly on the
Bridge Burner Head.
8
Burner Cap
Lip
Fig. 8
Incorrect Burner Cap
Placement - Fig. 10
Bridge Burner Head
Bridge
Burner
End
Cap
Bridge
Burner
Center
Cap
Bridge
Burner
End
Cap
Fig. 12
Igniter
Hole
Igniter
Hole
Tabla de contenido
