Gude GH 5.6-50 Traducción Del Manual Original página 38

ENGLISH
34
careful not to insert metal pieces, stones, bottles,
cans, or other foreign objects.
Switch off the device immediately and wait until all
moving parts have come to a standstill in the event of
a foreign object being struck or if the device begins to
make unusual noises or vibrate. Disconnect the ma-
chine from the power source and take the following
steps before restarting and operating the machine:
· check for damage;
· replace or repair damaged parts;
· check for loose parts and tighten them.
Do not allow processed material to accumulate in the
ejection area as this may prevent proper ejection and
cause the material to bounce back through the feed
opening.
Never touch under the housing body when the
engine is running.
Keep the power source free of debris and other build-
ups to prevent damaging it or a possible fire.
Stop the device and disconnect it from the power
supply. Wait until all rotating parts have stopped and
the appliance has cooled down.
· whenever you leave the lawnmower
· before removing blockages
· before checking, cleaning or working on the
device
· after contact with a foreign object, to check the
device for damage
· before freeing the device from accumulated
material
· before tilting or transporting the device
When working with this machine, do not use spare
parts other than those recommended by us. Using
spare parts not recommend by us can result in serious
injuries to persons or damage to the machine.
Safety instructions for gasoline
powered appliances
Risk of fire! / Risk of explosion
highly flammable.
Petrol and petrol vapours are highly flammable,
explosive.
Do not work with the unit in an environment with
a risk of explosion where there are flammable
liquids, gases or dust.
Never operate the unit near highly flammable
materials. Prohibited smoking and open fire
using.
Keep the fuel in suitable containers only.
The appliance may only be refuelled outdoors
and not near open fire or burning cigarettes.
For safety reasons, fuel tanks and other tank connec-
tions must be replaced in the event of damage.
Emergency procedure
After use, let the unit cool down for at least 5 minutes
before refuelling.
In the tank pressure may develop. Loosen the
tank cap slowly to allow this pressure to gradually
decrease.
Make sure the fuel does not overflow. If the fuel
overflows, the engine must not be started. Remove
any dirt from the appliance and prevent any attempt
at ignition until fuel fumes have evaporated.
Replace all fuel tank and container caps securely.
Start the device at least three meters away from the
place where you fuelled it. Do not smoke during
fuelling or operation and take care that no sparks or
open flames reach into the working area.
Fuel tank to be emptied outdoors only.
To keep the danger of fire as low as possible the engi-
ne and exhaust pipe must be free from grass, leaves
and excess grease.
Replace the exhaust pipe and (if necessary) the spark
protector if these are not in proper working order
any more.
To reduce fire risks, periodically clean the cylinder
flaps with compressed air and clear the silencer area
to get rid of sawdust, branches, leaves or other debris.
Electric shock Touching the spark plug
connector may result in an electric shock
when the engine is running.
Never touch the plug connector or the spark plug
while the engine is running.
Fuel is