Adjust The Cutting Diameter; Change To The Edging Mode; Pivoting Head Function; Maintenance - GreenWorks G24LT30M Manual Del Operario

EN
The line will extend approximately 0.4 in. with each stop
and start of the switch trigger until the line reaches the cut-
off blade and the cut-off blade cuts the excess length.
4.8 ADJUST THE CUTTING
DIAMETER
Figure 9.
The machine is set at a 254 mm cutting diameter. You can
adjust to a 305 mm cutting diameter.
Set the cutting diameter to 254 mm for greater runtime and
305 mmfor a larger cutting area.
1. Remove the battery pack.
2. Remove the blade screws from the cut-off blade.
3. Turn the cut-off blade 180°.
4. Tighten the blade screws.
4.9

CHANGE TO THE EDGING MODE

Figure 6.
You can change the machine to a well groomed edger for
edging patios, driveways and walkways or other areas.
1. Stop the machine.
2. Push on the edge button and turn the trimmer head 90
degrees until the trimmer head locks into position.
3. Release the edge button.
4.10

PIVOTING HEAD FUNCTION

Figure 10.
Adjust pivoting head to trim areas which are hard to reach
and for users to operate comfortably.
1. Stop the machine.
2. Push on the pivoting button and turn the shaft until the
trimmer head locks into required position.
3. Release the pivoting button.
5

MAINTENANCE

Read and understand the safety regulations and the
maintenance instructions before you clean, repair or do the
maintenance work on the machine.
NOTE
NOTE
NOTE
NOTE
IMPORTANT
English
Make sure that all nuts, bolts and screws are tight. Examine
regularly that you install the handles tightly.
Use only the replacement parts and accessories of the initial
manufacturer.
5.1

GENERAL INFORMATION

Only your dealer or approved service center can do the
maintenance that is not given in this manual.
Before the maintenance operations:
• Stop the machine.
• Remove the battery pack.
• Cool the motor.
• Store the machine in cool and dry place.
• Use correct clothing, protective gloves and safety glasses.
5.2

CLEAN THE MACHINE

• Clean the machine after use with a moist cloth dipped in
neutral detergent.
• Do not use aggressive detergents or solvents to clean the
plastic parts or handles.
• Keep the trimmer head free of grass, leaves, or excessive
grease.
• Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
• Do not spray water onto the motor and electrical
components.
5.3

REPLACE THE SPOOL

Figure 11.
1. Push the tabs on the sides of the trimmer head at the same
time.
2. Pull and remove the spool cover.
3. Remove the spool.
4. Replace with a new spool.
Make sure that the cutting line is in the guide slot on the
new spool, and is extended approximately 5 in. before you
install the new spool.
5. Put the end of the cutting line through the eyelet.
6. Extend the cutting line to release it from the guide slot in
the spool.
7. Push the tabs and install the spool cover onto the spool
housing.
8. Push the spool cover until it clicks into position.
6
IMPORTANT
IMPORTANT
IMPORTANT
NOTE