Cutter Installation - Solo 142 Manual De Instrucciones

Preparing the equipment for use

5.3 Cutter installation

Always switch off the engine, pull the spark plug
cap and wear protective gloves when fitting or
replacing the cutter!
A) Fitting the 3-tooth brush cutting blade
and the 4-tooth grass cutter (available as accessory)
Fig. 5
Place the brush cutting blade on the pressure
piece (25), ensuring that the cutting edges are
facing in an anti-clockwise rotational direction
(when looking at the tool in proper working
position).
Fix the pressure washer (26).
Place the nut protector (27) and turn safety nut
(28) onto the shaft.
Caution! Left hand thread - tighten counter
clockwise.
Take care that all parts are centered.
Block the shaft with the stop pin (4) and tighten
nut.
It is imperative that the safety nut (28) is
replaced, if it has become loose due to
frequent rem oval and tightening.
ENGLISH 10
B) Fitting the line head (available as accessory)
Fig. 6
The following parts are to be removed prior to
installation:
Lock nut (28)(left-hand thread!-counter-clockwise),
nut protector (27), pressure plate (26), metal cutting
attachment.
When working with the string head assemble in
the lower position. Insert the line cutter (Fig. 3
Pos. 24).
Fit the anti-winding protection (30) (supplied
with the line head) after the pressure piece (25).
The smooth side of the anti-winding protection
faces the gearbox.
Manually open the line head – left hand thread.
Block shaft with pin (29).
C) Fitting the Rototrim cutting head (available
as accessory)
Fig. 7