Carat C 2067 Manual De Instrucciones página 32

GB
1 1 5 5
WARNING !
BEFORE EVERY CUT MAKE SURE THAT THE
TILE TO BE CUT IS RESTING WELL AGAINST
THE TILE CLAMP.
With the C 2067/90 it is also possible to set:
a- the cutting length using the cut adjustment
knobs.
b- the cutting depth using the locking lever.
c- the cutting dimension using the tile clamp
square and the graduated rod positioned on
the work surface.
For any specific operations, it is possible to set any
cutting angle between 0° and 45° indicated on the
side of the machine. (Photo 16)
1 1 6 6
9. Laser marker
WARNING !
LASER APPARATUS IN C 2067/90 IIIA
635 nm, < 5 mW
Cutting can be sped up using the laser marker.
Indeed, the special laser system is capable of
marking out the line of the cutting line on the
working surface.
WARNING !
THE LASER MARKER STARTS WORKING AS
SOON AS THE MACHINE IS CONNECTED TO
THE POWER SUPPLY.
1 1 7 7
CUTTING USING THE LASER MARKER
- Connect the machine to the power supply;
- Position the piece to be cut, making the line
produced by the laser marker correspond with
the reference on the material to be cut;
- Proceed to cut as indicated in the paragraph
"making a flat cut".
(Photo 17)
WARNING !
DO NOT MODIFY THE POSITION OF THE
MARKER MAKING
OPERATOR'S EYES.
DO NOT LOOK DIRECTLY AT THE BEAM
WITHOUT PROTECTION FOR YOUR EYES, OR
WHEN USING OPTICAL INSTRUMENTS.
ADJUSTING THE MARKER
If the marker is not aligned with the cutting axis, it
can be realigned.
To position the marker correctly, proceed as follows:
- Slacken the three bulb locking screws in order
to allow it to move. (Photo 18)
32
IT SHINE INTO THE