Alarm Settings - König Electronic HAV-PR22 Manual De Uso

• Remove the batteries if you are not going to use the radio for a long time
• Remove empty batteries immediately
• Do not use old and new batteries together
TO USE AC ADAPTER
Connect the plug to the radio and the schuko plug to an AC wall outlet. The DC input is 4.5 V
outer + inner -.
CLOCK FUNCTION
1. To set the time press the "POWER" button to go into standby mode.
2. Press "TIME/SET/MEMORY" and use the "HOUR/+" and "MIN/-" to set the correct time.
3. After you are finished press the "TIME/SET/MEMORY BUTTON" again to save the settings.
4. Press "MODE" to view the time on the display.
RADIO OPERATION
1. Move the lock switch to the UP position.
2. Turn on the radio with the "POWER BUTTON".
3. Adjust the volume with the "VOLUME +/-" button.
4. Select the desired band using the "BAND/WAKE" button.
5. Tune to the desired station using the "HOUR/+" or "MIN/-" buttons. The frequency is displayed on
the display.
6. To improve reception, move the antenna.
7. To switch off the radio use the "POWER BUTTON".
HEADPHONE
If you want to listen via a headphone, lower the volume, connect the headphone and set the volume to
the desired level again.
NOTE: When the received signal is weak, or the batteries are low, the FM ST indicator may not show
up on the display, even though the sound can still be heard via the headphones.
AUTOMATIC TUNING
To automatically tune to the desired station press and hold "HOUR/+" or "MIN/-" for more than 2
seconds. The radio will then search for the next available station. For SW press the "METER" button
repeatedly to select a station.
DIRECT TUNING
To directly input the desired frequency, press the "ENTER" button and type in the frequency of the
desired station. Press "ENTER" to confirm.
PRESETS
This radio is able to store 40 preset stations, with a maximum of 10 on each band. When you are
listening to the station you want to store, follow these steps:
1. Press "TIME/SET/MEMORY", MEMO will blink in the display.
2. Press a preset number (0-9).
3. Press the "TIME /SET/MEMORY" button again and the station will be stored.
NOTE: Storing a station needs to be completed in succession without any pauses.
To select a stored preset station, first select the desired band and then press the numerical key which
corresponds with the stored station.

ALARM SETTINGS

TO SET THE ALARM
1. Switch to standby mode.
2. Press the "BAND/WAKE" button repeatedly to select the desired alarm (OFF, BUZZ, RADIO).
3. Hold the "BAND/WAKE" button until the time starts flashing.
4. Set the desired alarm time using "HOUR/+" or "MIN/-" and press "BAND/WAKE" to confirm.
3