Beper 50.921 Manual De Instrucciones página 10

Vacuum Cleaner Use instructions
WARNING:
Important:
If the suction opening of the unit, the hose or the tube is blocked, switch off the vacuum clearer and
remove the blocking substance before you start the unit again.
1. Do not operate the vacuum cleaner too close to hearter or radiators.
2. Before inserting the power plug into the wall outlet, make sure that your hands are dry.
3. Before you start the unit, make sure to remove large or sharp objects that might damage the dust
tank and hose.
4. When pulling out the power plug from the wall outlet, pull the plug not the power cord.
5. Do not use without all filters in place.
6. When using, if you learn of squeak from the cleaner, it must be suction appears to be reduced, so
you must stop (make sure the cleaner is not plugging), then clean the all air filter.
Note: If the supply cord is damaged, it must be replaced by manufacture, service agent or similarly
qualified person in order to avoid a hazard.
WARNING: Hold the plug when rewinding the cord. Do not allow the cord to whip when rewinding.
Description of the appliance
1. Hose
2. Full bag indicator
3. Bag compartment release Button
4. Rewinding cord button
5. Power speed control
6. Power on / off
7. Wheel
8. Telescopic metal tube
9. Floor Brush 2 positions
13
10. Bag's Tab
11. Bristle brush
12. Crevice tool
13. Pressure regulator
Use and function
Assembling vacuum cleaner
Note: Always remove the power plug from the wall outlet before assembling or removing accesso-
ries.
1. Attaching the Flexible Hose into the vacuum connect the flexible hose into the air intake duct,
push in until you hear a "click", indicating it is in its locked position.
2. Fitting the tube to the curved wand/hose extension. Push the tube into the curved wand/hose
extension.
3 . Attaching the small brush and small crevice on the extension tube by using the connector
4. Fitting the Floor Brush to the tube. Push the tube into the floor brush. Adjust the tube to the de-
sired length.
Variable suction control
Note:Once all attachments are in place, unwind a sufficient length of cable and insert the plug into
the wall outlet. A yellow mark on the power cord shows the ideal cable lenghth. Do not pull the power
cord beyond the red mark.
10
1. Insert the power plug into the wall outlet.