Setting Up And Connecting; Battery Precautions - König Electronic HAV-MCS30 Manual De Uso

Remote Control
31. Infrared Transmitter
32.  STANDBY Button
33. iPod ® Button
34. PLAY MODE/ST/MO Button
35.  STOP/PS+ Button
36. VOL + Button
37.  / TUNING+ Button
38. SLEEP/12/24HR Button
39. ID3 Button
40. TIMER Button
41. PROG/CLK ADJ Button
42. OPEN/CLOSE Button
43. MODE Button
44. FOLDER+ Button
45. MUTE Button
46. AUX Button
47. TUNER/BAND Button
48. CD/SD/USB Button
49.  / PS– Button
50.  / TUNING – Button
51. VOL – Button
52. Numerical 0 - 9 Buttons
- "2" button with  roll up, "8" button with  roll down
- "4" button with Repeat, "5" button with ENTER, "6" button with MENU
53. EQ Button
54. FOLDER – Button

SETTING UP AND CONNECTING

Replacing battery of the Remote Control
The remote control battery is already installed at the factory. If the remote control stops
operating, replace the battery with a new one.
1. Squeeze the notched tab A while pulling the battery
door latch B out to take the battery holder out.
2. Insert a "CR2025" 3V lithium battery. Make sure the
polarity (the + and – side of the battery) is correct.
3. Replace the battery holder back in the remote control

BATTERY PRECAUTIONS

Follow these precautions when using a battery in this device.
1. Use only the size and type of battery specified in this manual.
2. Make sure you install the battery according to the polarity indicated in the battery
compartment. Reversed polarity may cause damage to the device.
3. If the device is not going to be used for a long period of time, remove the battery to
prevent damage or injury caused by possible battery leakage.
4. Do not try to recharge the battery, it's not intended to be recharged and doing so
may cause the battery to rupture or leak.
4