LG WM3488H Serie Manual De Propietario página 37

Ocultar thumbs Ver también para WM3488H Serie:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Problem
ü
Did you remove the load immediately
Wrinkling
after it finished?
Did you overload the tub?
ü
ü
Did you reverse the hot and cold water
inlets?
ü
Is the power cord plugged in properly?
Power will not turn on
Has a house fuse blown, a circuit
ü
breaker tripped, or a power outage
occurred?
ü
Is the temperature in the tub too high?
The door does not open
when the cycle pauses or
finishes
Is the water level in the washer high?
ü
Is the washing machine overloaded?
ü
The wash cycle time is
Are other options added to the wash
longer than usual
cycle?
ü
Has the incorrect detergent been used?
It is musty or moldy in the
tub
Did you clean the tub periodically?
ü
ü
Plumbing in the home moves or flexes
Banging noise when
when the water valves in the washer
washer is filling with
shut off.
water (Water Hammer)
Household water supply pressure is
ü
very high.
Possible Causes
TROUBLESHOOTING
Solutions
ü
Remove the load immediately after it
finishes.
Do not overload the tub.
ü
ü
Hot water rinse can cause garments
to wrinkle. Check the inlet hose
connections.
ü
Make sure that the plug is secured in a
grounded 3-prong, 120 V (60 Hz) outlet.
Reset the circuit breaker or replace the
ü
fuse. Do not increase the fuse capacity.
If the problem is a circuit overload,
have it corrected by a qualified
electrician.
ü
The washing machine has a safety lock
built into the door to prevent burning.
Leave the door closed and wait until
the door lock icon disappears from the
display.
Allow the washer to complete the
ü
programmed cycle, or press the SPIN
button.
This is normal. The washing machine
ü
automatically adjusts the cycle time for
the amount of laundry, water pressure,
water temperature, and other operating
conditions.
ü
Use only HE (High-Efficiency) detergent
recommended for a front-loading
washing machine.
See page 30, clean the inside and
ü
outside of the washing machine
periodically.
ü
Water hammer is not caused by a
defect in the washer. Install water
hammer arrestors (purchased
separately at hardware or home
improvement store) between the fill
hose and the washer for best results.
Adjust household water supply
ü
regulator to a lower pressure or
contact a plumber to have a regulator
installed.
37

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido