Putting Into Service - QUNDiS gateway 5 Instrucciones De Uso Y De Instalacion

Putting into service

The installation variant depends on the settings in the Q SMP.
Manual installation (auto scan)
Automatic installation (auto install)
To start up the gateway, the gateway must be in „NEW" mode.
the display
Manual installation (auto scan)
•
remaining steps are run through automatically.
•
•
Displays during auto scan
UMTS,
Starting the scanning process.
tively in the display
4
Example:
3 sec
V2.1 / 14.03.2019
Operating and Installation Instructions Q gateway 5 - EN
4
1
. In this case the gateway is reset to sleep mode.
1
3 sec 3 sec
5 min
continuously. For example, while the display loop is running, a node with a better
is displayed.
FUM5-00AM-DES-G5021
1
NEW
again or wait 6 seconds.
1
.
are shown on the display
3 sec
5 lights up green. The
ABORT
1
4 SYNC
4 .
4 SCAN
-
-
-
29