Wall Mounting - QUNDiS gateway 5 Instrucciones De Uso Y De Instalacion

EN - Operating and Installation Instructions Q gateway 5

Wall mounting

ATTENTION!
Flush-mounted supply lines (electricity, water, EDP network, etc.) can be damaged!
-
positions.
Electrical Installation Q gateway 5 RNG5N00R1x
Dangerous electrical voltage
After opening the housing, certain parts of this device that may be under dangerous voltage become acces-
sible. Failure to observe these warnings may result in personal injury and damage to property.
Disconnect the device from the mains before carrying out any work on RNG5N00R1x it!
-
easily accessible to the service technician.
-
-
• Push the cable through the enclosed union nut.
• Then pass the cable through the cable gland already
Q gateway 5 mounted on the cable.
•
• Screw the union nut to the cable gland.
• Close the power supply compartment
28
1
2x
2
7
.
FUM5-00AM-DES-G5021
3
Cable type NYM-J 3 x 1,5 mm2
65 mm
Mains connec-
6 mm
V2.1 / 14.03.2019
tion