Idiomas disponibles
Idiomas disponibles
Align the holes of the PE pad and the windscreen holder and tighten the screws (P11)
– on the right and on the left.
Mounting the MRA windscreen to the motorcycle:
10.Mount the MRA windscreen to the motorcycle using the original screws and tighten
the screws with 4NM (P12).
11.Turn the height adjustment of the windscreen to the uppermost position and connect
the windscreen to the stabilizer (P13) using the supplied M5x16 lens head screw
[11092] and the plastic washer [10635]. Tighten the screws evenly.
Final inspection and functional test:
12.Loosen the thumbscrews on the right and left and raise and lower the windscreen
with the handwheel.
With the thumbscrews tightened, you can't adjust the height of the windscreen.
Please note: while driving, the thumbscrews must be firmly tightened. To adjust the
height of the windscreen, the thumbscrews must be loose.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: [email protected]
spirits to clean the screen as they will damage it.
5
