Tool Use And Care; Service; Specific Safety Rules - ENAR BACKPACK Serie Manual De Instrucciones

KEEP proper footing and balance at all times.
USE safety equipment.
Always WEAR eye protection.

4.3 TOOL USE AND CARE

DO NOT FORCE tool.
USE the correct tool for your application.
DO NOT USE tool if switch does not turn it on or off.
STOP the machine before making any adjustments, changing accessories, or storing the tool.
STORE idle tools out of reach of children and other untrained persons. .
CHECK for misalignment or binding of moving parts, breakage of parts, and any other condition that
may affect the tools operation.
If damaged, HAVE the tool serviced before using.
USE only accessories that are recommended by the manufacturer for your model.

4.4 SERVICE

Tool service MUST BE PERFORMED only by qualified repair personnel.
When servicing a tool, USE only identical replacement parts.
FOLLOW instructions in the Maintenance section of this manual.

4.5 SPECIFIC SAFETY RULES

For your own safety,
this equipment, please read carefully the instructions
1.- For the proper use of this device, please assure that the operator has been correctly
informed of the content of this manual before using it.
2.- This machine must be used only under the applications for which it has been designed
and according to these safety instructions.
3.- Do not touch any part of the vibrating group when the motor is running.
4.- Do not work in an area exposed to flammable liquids or gases.
5.- Do not allow inexperienced or not trained personnel to use the machine.
6.- Please secure all the threads and bolts before working.
7.- Do not stop the machine until the concrete mass is fully vibrated.
8.- Do not work with the machine if any type of dysfunction, even small, has been observed.
9.- Do not connect the flexible shaft to the motor when this is working.
10.- Do not operate in the motor shaft when this is working and without transmission
11.- Do not work with transmission or poker in bad conditions, the motor overheats.
12.- Do not permit untrained personnel to operate the motor or connections.
13.- Read the engine manufacturer's manual before working.
14.- Do not work in closed rooms, the exhaust fumes may be toxic.
15.- Wait 2 minutes for the petrol refill until the motor gets cold.
16.- Keep the air intake clean and opened for the correct running of the motor.
17.- The specification according to ISO3744. The sound pressure level at operator's location
(LpA) is 95dB and sound power level (Lwa) is 101 dB (K=1,5dB). The test is had with the
engine operating at full throttle and AX45 poker. Proper protective equipment should be used.
18.- The hand-arm vibration transmitted to the operator does not exceed 2,5 m/s
acceleration (engine operating at full throttle with AX45 poker measured according to ISO5349
at 1 meter from the poker in backpack and on the handle in vibbar (K=1m/s
IN ADDITION, LOCAL COUNTRY ESTABLISHED ORDINANCES SHOULD BE RESPECTED.
BACKPACK / VIB-BAR - FLEXIBLE SHAFT AND POKERS
as well as for the others one, and in order not to cause any damage to
TBX0,5, TDX2m – BACKPACK / VIB-BAR
that are explained as follows:
2
)).
AX25, AX32, AX45
en
2
of
5