How Toconnect Thewater S Upply - Sears KENMORE ELITE 596.72282200 Manual De Uso

Installing Your Refrigerator
How to Connect the Water Supply
WARNING
To reduce the risk of injury or death, follow basic precautions, including the following:
•
Read all instructions before installing device.
• DO NOT attempt installation if instructions are not understood or if they are beyond personal skill level.
• Observe all local codes and ordinances.
• DO NOT service device unless specifically recommended in owner's manual or published user-repair
instructions.
• Disconnect power to unit prior to installing device.
CAUTION
To avoid property damage or possible injury, follow basic precautions, including the
following;
• Consult a plumber to connect copper tubing to household plumbing to assure compliance with local codes and
ordinances.
• Confirm water pressure to water valve is between 20 and 100 pounds per square inch. If water filter is installed,
water pressure to water valve must be a minimum of 35 pounds per square inch.
• DO NOT use a self-piercing, or 3/16"saddle valve! Both reduce water flow, become clogged with time, and
may cause leaks if repair is attempted.
• Tighten nuts by hand to prevent cross threading. Finish tightening nuts with pliers and wrenches. Do not
overtighten.
• Wait 24 hours before placing unit into final position to check and correct any water leaks.
Materials Needed
1/4" outer diameter flexible copper tubing
NOTE: Add 8' to tubing length needed
to reach water supply for creation of
service loop.
•
Shut-off valve (requires a 1/4" hole to
be drilled into water supply before
valve attachment)
• Adjustable wrench
114"hex nut driver
Create service loop with _ [ _ Slide brass nut over sleeve
l tubing using care to avoid _ J and screw nut into inletport.
kinksintubing. _0 _
[
Tightennutwithwrench. 1
.;j IMpoRtANt: DO NOT o ve,ighten.
Cross threading may occur.
"I
_. Remove plastic cap from c'_
re'water valve inlet port.
6
I3
Place brass nut (A) and A\ B
sleeve (B) on copper _ _LX I
tube end as illustrate
' .J
"x
Place end
of
copper tubing into_ _ _-\_ hours. Correct leaks, if necessary. J
4
watervalveinletport. Shape _]ll I 7M°nit°rwaterc°nnecti°nf°r24
tubing slightly-OO NOT KINK- HI
so that tubing feeds straight _ll l
into
inlet
port.
_ _J