Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Cleaning Instructions
IMPORTANT:
Do not use wire brush, scouring pad, etc., as they may damage the filters.
Rinse filter under running water until most soils are removed. If you
have hard-to-remove
soils or calcium deposits from hard water, a
soft brush may be required.
Filter Reinstallation Instructions
1. Noting the previous illustrations, place the Lower Filter under the Locating Tabs in the
bottom of the dishwasher so the round opening for the Upper Filter Assembly lines up with
the round opening in the bottom of the tub.
2. Insert the Upper Filter Assembly into the circular opening in the Lower Filter.
3. Slowly rotate the filter clockwise until it drops into place. Continue to rotate until the filter
is locked into place. If the filter is not fully seated (still turns freely), continue to turn the
filter clockwise until it drops and locks into place.
g tab
To replace
Upper
Filter
Assembly
IMPORTANT: To avoid damage to dishwasher, do not operate your dishwasher without the ULTRACLEAN
TM
filters properly installed.
Be sure the Lower Filter is securely in place and the Upper Filter Assembly is locked into place. If the Upper Filter Assembly turns
freely, it is not locked into place.
DISHWASHER EFFICIENCY TIPS
Hot water
dissolves
and activates
the dishwasher
detergent.
Hot water
also dissolves
grease
on dishes and helps glasses dry spot-
free.
For best dishwashing
results, water
should
be 120°F (49°C)
as it enters the dishwasher.
Loads
may
not wash as well if the water
temperature
is too low.
Additional
efficiency
tips
•
To save water, energy and time, only scrape dishes. Do not rinse dishes before putting them into the dishwasher.
•
Use a delay feature to run your dishwasher during off-peak
hours. Local utility providers recommend avoiding
heavy usage of
energy at certain times of day.
•
During the summer, run your dishwasher at night. This reduces daytime
heat buildup in the kitchen.
•
Use a rinse aid to improve drying.
10
Tabla de contenido
