GrillMaster 720-0783 Manual Del Usuario página 17

(e) Push control knob (U) onto valve control stem,
and tighten use hex wrench. See Fig.27.
(f) Plug ignition wire into igniter wire hanging from
electrode on underside of burner. See Fig.28.
7. Igniter and Battery Assembly
(a) Remove igniter cover and lock washer from
igniter. Insert igniter through from back of side
burner control panel, secure lock washer from
front of side burner control panel. See Fig.29.
(b) Install battery (V) into ignition box with positive
terminal facing outward.
(c) Replace the ignition battery cap after the
battery has been installed. See Fig.29.
Note: Make sure the igniter is assembled
with the wires upward in order that the wires
are away from manifold enough.
See illustration below:
Igniter Manifold
Fig.27
U
Fig.28
Fig.29
v
Lock Washer
l ock w asher
17