Recalling Test Result And Average - BIONIME GM550 Manual Del Usuario

Recalling Test Result and Average

Rightest ®
The Blood Glucose Meter GM550 is able to store 500 test results with time and date automatically. If your
meter has stored 500 results, which is the maximum memory of the meter, the newest test result will replace the oldest
one. To recall your test memory, start the meter without test strip inserted.
1. Press the main button to switch from the time mode to the Memory screen. First you will see the "MEM"
symbol on the up per left corner of the display. When you press the right button, the latest result will be
displayed. By pressing the right button sequentially former test results will be shown in historical
order.You will see the sequence number on the lower right corner and the year on the lower left corner
of the display followed by date and time of the measurement.
Note: The right button is for reviewing the tests with sequence number increasing, and the left button is for reviewing tests
with sequence number decreasing. The sequence no "1" is the latest result while sequence no "500" is the oldest test result.
2. To finish reviewing memory tests, press main button again, and you will enter the Average screen. By pressing the right
button, the display shows "AVG" on the upper right corner of the display and the average value for the actual day. By
sequencely pressing the right or left button you will get to the 1-days,
your blood glucose values.You will see the number of the calculated days on the lower left corner and the number of
the calculated readings on the lower right corner.
40
7-days, 14-days, 30-days and 90-days average of
3. Non-Averaging set and canceled:
You may select the unwanted or doubtful test results, to exclude them from the average calculation, after your every test. After you finished
your test in the test mode, you can exclude the unwanted result. Keep pressing the right button until you see the symbol "NO AVG" in the
top right corner of the screen. By keeping the right button pressed and pressing the main button simultaneously to confirm the value as
"Non average".
Now this value is flagged by the symbol "NO AVG" in the up per right corner of the screen.
If you want to cancel this non-averaging setting, you have to stay in the test mode. First keep pressing the right button until the "NO AVG"
symbol changes to "AVG" in the up per right corner of the screen. To confirm this original status you again simultaneously press the main
button to confirm the "AVG" status. Now the value will be stored as a regular value and included in the average values.
NOTE
- The average function is related to the time setting. You must set the time right and have enough time intervals on the basis of current inquiry time,
to make sure that the average test results will show. Use the 14-day average for example; if your current inquiry time is 2010/1/30, then that you
must check that you have tested blood glucose in the past 14 days before 1/30, including today . If not, the 14-day average will show no figure.
- The Non-averaging/re-averaging function only works in the test mode and when you get the value. In the MEM mode, you can not perform this
action.
Recalling Test Result and Average
41