nedis WEST203WT Manual De Uso página 3

6. C/F Button
Press the C/F button to switch the temperature display between C/F. Press
and hold button for 3 seconds to force the unit to enter the RCC reception.
7. 12/24 Hr Button
Press 12/24-hour button to toggle between 12/24-hour formats.
8. Use Snooze
When alarm activates, press SNOOZE to stop the alarm sound, alarm will
sound again after 5 minutes.
9. MOON PHASE
It will calculate the moon phase automatically according to the calculator,
the moon phase being divided into 8 degrees.
Temperature and Humidity:
1. Temperature range indoors: 0 °C~50 °C (32 °F~122 °F);
Temperature range outdoors: -50 °C~70 °C (-58 °F~158 °F).
2. Range of humidity: 20%–99%.
3. Tendency of temperature change: one check per hour, compared to
previous data. If the temperature changes more than 1 °C the arrow will be
flat.
RCC Reception Mode:
1. RCC reception format: DCF, the reception time is about 10 minutes.
2. RCC reception way.
3. It will begin to receive the RCC 3 minutes after turning on the unit.
4. RCC reception graphic:
The tower graphic flashes when receiving, the tower graphic will also flash
when lost or no signal. The tower graphic will not flash when synchronizing
the signal, but the arc-shaped antenna symbol on top of the tower
graphic is flashing. The whole RCC reception graphic will display when the
reception is successful: The tower graphic will turn off and exit RCC when
the signal reception fails.
Part II
There are 7 buttons at the rear: LIGHT, CHANNEL, RESET, DOWN, UP, ALARM/
SET, TIME/SET. These buttons are used for the following functions:
1. LIGHT Button
In normal display mode press this button, the LED will light up.
ENGLISH