Mounting Instructions - Sunbeam 1626 Manual De Instrucciones

O
PERATING
This dryer is equipped with an appliance leakage circuit interrupter (ALCI) for your safety.
This device is designed to make the appliance inoperable under some abnormal conditions
(such as accidental immersion in water).
After the appliance is plugged in, you must check your protective device as follows:
1. Press the "Reset" button on the ALCI device.
2. Press the "Test" button. The "Reset" button will pop out. This verifies
that the protective device is working properly.
3. Press the "Reset" button once more to reactivate the safety device
and use your appliance.
REPEAT THE ABOVE PROCEDURE BEFORE EACH USE TO CONFIRM
THAT THE PROTECTIVE DEVICE IS OPERATING.
If your protective device does not operate as described above, the entire appliance
should be returned to Sunbeam Appliance Service Station, 95 W.L. Runnels Industrial
Drive, Hattiesburg, MS 39401 for examination or repair.
T
1. Press the release buttons to remove the dryer.
2. To start the dryer, press the ON button on the wall mount unit.
3. Slide the control switch to: LOW position for styling hair, MED position for drying hair,
HIGH position for fastest drying.
4. Stop the dryer by pushing the OFF button or by replacing the unit to the mounting
base, which will automatically engage the OFF switch.
W M
ALL OUNT
R
ELEASE
B
UTTON
I
NSTRUCTIONS
U
O SE
H D
AIR RYER
OFF
B
UTTON
HIGH
MED
LOW
S
WITCH
ON
B
UTTON
4
For your protection, this unit contains a thermostat that prevents the dryer from
overheating. Should the air intake and/or air outlet become blocked or obstructed, the hair
dryer will automatically shut off. If this occurs, slide the switch to OFF, unplug and allow
dryer to cool. If dryer continues to turn off automatically, discontinue use and return to
Sunbeam Appliance Service Station, 95 W.L. Runnels Industrial Drive, Hattiesburg, MS
39401 for examination or repair.
C
Use your Sunbeam hair dryer with care. Directing a high volume of heat continuously to
one area can overheat hair and scalp. When using a "High" heat setting, hold the blower
opening a few inches away from the hair, drying one section at a time. Work layers of hair
in quick strokes. Keep the dryer in motion until drying and styling are complete.
M
OUNTING
For use on sheetrock or wood walls only.
The Sunbeam Wall Mount hair dryer is designed for installation on sheetrock or wood
walls only. To mount onto wall, be sure there are no hidden electrical circuits or pipes
in the mounting location.
Follow these instructions:
1. Remove wall bracket from the unit.
2. Use the bracket as template to mark position of holes for drilling close to electrical
outlet, away from tub or sink.
3. Drill three 3/16 inch holes.
4. Insert the three anchor bushings by tapping lightly with a hammer until the shoulder
of the bushing rests against the wall.
5. Position wall bracket and tighten the two bottom screws first, then tighten the top
screw. (Anchor bushings and screws are provided for you).
6. Match the slots on the back of the mounting base with the hooks on the bracket.
7. Press bracket onto the hooks and slide down to insure secure mounting.
8. Plug the unit into the nearby electrical outlet (110 volt, 50 – 60 cycle AC only).
D
To reduce risk of electrocution, do not install where unit can fall into tub or sink.
AUTION
I
NSTRUCTIONS
ANGER
5