Tabla de contenido
Idiomas disponibles
Idiomas disponibles
fitting
on
the
regulate the water level in the
tank, as shown in FIGURE 10.
This
is
recommended
WetDeks located in hot climates
where evaporation will have a
greater effect on water levels.
5. VALVE
BOX:
manifold needs to be moved
closer to the pad because of
distance
(maximum distance from the
valve manifold to furthest nozzle
is 50'), it is recommended that
the valves be buried and placed
in a standard green valve box
used for sprinkler systems. This
can be used for either the Stand
Alone or Poolside versions.
WETDEK AQUADIRECTOR CONTROLLER INSTALLATION
The WetDek System Controller requires an onsite licensed electrician to install. These guidelines
should be used to insure that the controller has been installed properly.
FIGURE 11
1. FIGURE 11 shows the internal wiring for the WetDek AquaDirector Controller. The WetDek controller
is manufactured to handle 120V input; this diagram shows how to install the standard configuration
for 120V power. Please read this section carefully to prevent damage to the circuit board. All
circuit boards are tested twice before they leave our shop to insure that they are operational. A blown
circuit board is not covered under warranty.
Reservoir
to
for
If
the
valve
FIGURE 10
requirements
9
Tabla de contenido
