Installing The Ieee 1394 (Firewire) Interface Board - Nikon SUPER COOLSCAN 9000 ED Manual Del Usuario

Problem
• Other IEEE 1394 devices are connected and turned on
• Interface board is not compatible
Computer does not
recognize scanner
(continued)
• Interface board is not correctly installed
• Scanner device driver is missing or corrupted (Windows only)
• Nikon Scan is not correctly installed
• IEEE 1394 drivers require updating (Windows 98 SE only)

Installing the IEEE 1394 (Firewire) Interface Board

Installing the IEEE 1394 (Firewire) Interface Board
Users whose computer is not equipped with a compatible IEEE 1394 interface must install
the supplied IEEE 1394 (Firewire) interface board (Macintosh users should note that beige G3
computers are not equipped with a built-in Firewire interface). To install the board, follow
the steps below.
Operating system
Windows XP
Windows 2000 Professional
Windows Me
Windows 98 SE
Mac OS
Computers Without an Empty Full-Sized PCI Slot
The supplied IEEE 1394 board can only be installed in a full-sized PCI slot. It can not be installed in laptop
computers or in computers with a low-profi le PCI slot. For information on other approved boards and
PCMCIA cards, see the Nikon web site for your area (
64
Disconnect the other devices. If the scanner is connected via a hub,
adapter, or extension cable, disconnect the scanner and reconnect it
directly to the computer. If this does not solve the problem, unin-
stall all software that uses the IEEE 1394 interface and reinstall Nikon
Scan.
At the time of writing, operation has been confi rmed only with the
interface board provided with the scanner. Operation is not guaran-
teed with other boards or with built-in IEEE 1394 ports. Install the
supplied interface board (desktop computers) or consult a Nikon ser-
vice representative for information on approved IEEE 1394 interface
boards or cards.
Check the documentation provided with interface board or card.
Check that the device driver is correctly installed.
Uninstall and reinstall Nikon Scan. For more information, see the
Nikon Scan Reference Manual.
Update the IEEE 1394 drivers.
1 Install the interface board. The board device drivers will be
installed automatically when the computer is turned on.
2 Confi rm that the board is correctly registered in the Windows
Device Manager.
1 Update the IEEE 1394 drivers.
2 Install the interface board.
3 Install the drivers for the interface board.
Install the interface board.
Possible cause
Installation
2).
5, 22
10, 15,
64–69
64–69
74–75
10–18,
70–72
65
66
66–67
65
66
68–69
66