Tabla de contenido
GENERAL MAINTENANCE
1.
Do not place the machine in hot, dusty or damp locations.
2.
To clean the housing use a silicon-treated cloth. Do not use water or detergents.
3. Do not place anything on the housing, particularly on the head of the printer
mechanism.
4.
Turn off the power switch before removing the plug from AC wall outlet.
5.
Turn the power switch off while not in use.
REPLACING THE RIBBON
Your calculator is shipped with a 2-color ribbon already in place. You do not need to install
or change it before you begin using the calculator. When you have been using your
calculator for some time, however, the print will gradually become faint, indicating that you
should change the ribbon. To change the ribbon, follow these steps.
1.
Remove paper roll, tearing paper at rear of calculator. Use the Paper Advance
key
to feed the remaining paper tape through the printer. Then remove the printer
cover.
2.
Remove the old ribbon by pulling upward.
3.
Install the ribbon spool with the black edge up. Roll from the outside of the full spool
and place the first spool on the spindle not engaged by the lever. Thread the new
ribbon along the outside of the guides and in front of the print wheels. Switch the lever
to the other side and replace the second spool.
4.
Rotate the spools to take up any slack. Replace the printer cover and the paper tape.
(Replace with Victor Ribbon #7010)
HOW TO FEED THE PAPER TAPE
1. Put the new paper roll in the paper holder, slightly opening the paper holders.
2. Insert the paper into the slot as indicated.
3. Depress the paper feed key.
4. Suitable paper roll:
Correct Direction
Width:
max. 58mm (2.25")
Diameter:
max. 80mm (1.97")
Paper:
Normal paper
(45kg/1000 sheets/788 x 1091 mm)
3
Incorrect Direction
( )
Tabla de contenido
