Requirements For The Installation Location - Graef MS 61 Manual De Instrucciones

Milk frother MS 61 / MS 62 / MS 80 / MS 85
Scope of delivery and
shipping inspection
The unit comes standard with the
following components:
Mil frother (base station and
●
tank with cap)
Attachment for hot milk
●
Attachment for cold milk
●
● Operating instructions
important!
► Check the delivery for
completeness and for visible
damage.
► Immediately notify the car-
rier and the supplier about
an incomplete delivery or
damages due to improper
packing or caused by ship-
ping.
Unpacking
To unpack the unit, proceed as be-
low:
Take the unit out of the carton.
‹
Remove all pieces of the pack-
‹
ing.
Remove any possibly extant
‹
labels from the unit (do not
remove the rating plate).
Disposing the packing
The packing protects the unit from
shipping damage. The packing
materials are selected for their en-
vironmental compatibility and from
disposal aspects; they are recycla-
ble.
Returning the packing to the waste
disposal system saves raw materi-
als and reduces the accumulation
of waste. Dispose packing material
that is no longer needed at a col-
lection point for the »Green Point«
recycling system.
important!
If possible, save the original
►
packing during the unit's
warranty period to be able to
properly pack it up in case of
a warranty claim.
Requirements for the
installation location
For safe and flawless operation of
the unit, the place of location must
meet these prerequisites:
The unit must be set up on a
■
firm, flat, level, non-slip and heat
resistant base that has sufficient
load bearing capacity.
■ Select the place of location so
that children cannot reach the
hot surfaces of the unit.
■ The unit is not intended for in-
stallation in a wall or a built-in
cupboard.
© Gebr. Graef GmbH & Co. KG - 02
EN
19