Removing Cable - Greenlee G10 Tugger Manual De Instrucciones

Removing Cable

Removing old cable involves the same principles
as installing new cable. However, there are some
important differences.
Pulling Force
It is dif cult to predict the amount of pulling force
necessary to remove an old cable. The cable may be
damaged, and it may break with an unexpectedly low
pulling force.
The required pulling forces may be very high:
• The cable has probably "taken a set." Unlike the new
cable on a reel, cable in conduit has probably been in
the conduit for years, or perhaps decades. The cable
will resist bending and straightening as it is pulled
through the conduit.
• The pulling lubricant has probably hardened,
increasing pulling resistance.
• The insulation may be damaged and the cable may
be corroded.
• Dirt or other foreign matter may have entered the
conduit and may have cemented the cable in place.
Greenlee Tools, Inc.
G10 Tugger™ Portable Cable Puller
Puller Placement
Pulling out old cable is generally accomplished with the
puller located some distance away from the end of the
conduit. This allows the pulling crew to pull out a long
section of cable before turning off the puller, cutting
off the cable, and reattaching the grip(s). Mounting the
cable puller a distance away from the end of the conduit
increases the amount of exposed rope, which greatly
increases the amount of violent whipping action which
would occur if the rope were to break.
To isolate the operator from the rope path:
• Locate the puller so that you will stand behind an
obstruction, such as a wall. Set up the puller so that
you will be able to maintain control of the pull. You
need a clear view of the rope as it feeds onto the
capstan, including several feet of the rope in front of
the capstan. You must be able to turn off the puller
before the pulling grip, connector, or swivel contacts
the capstan.
• Use an additional pulling sheave (if necessary)
to change the direction of the tailing rope. Anchor
the sheave so that you are close enough to maintain
control of the pull. You need a clear view of the rope
as it feeds onto the capstan, including several feet of
the rope in front of the capstan. You must be able to
turn off the puller before the pulling grip, connector,
or swivel contacts the capstan.
Note: Use the additional pulling sheave to change
the direction of the tailing rope (after the rope leaves
the capstan). Do not change the direction of the
pulling rope.
• Use a longer tailing rope than usual and stand
away from the puller. Stand as far from the puller as
possible, while maintaining control of the pull. You
need a clear view of the rope as it feeds onto the
capstan, including several feet of the rope in front of
the capstan. You must be able to turn off the puller
before the pulling grip, connector, or swivel contacts
the capstan.
26
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070