Maintenance And Cleaning; Installing Filter; Removing And Cleaning Filter; Troubleshooting - Kawasaki 692358 Manual De Instrucciones

3. Remove the powerhead and set aside in open air for at least an hour for motor
to cool down.
4. Meanwhile, check for problems; over–filled bag or clog in various points in the
vacuum.
5. After an hour cool-down time, reinstall the powerhead on the tank.
6. Reconnect vacuum cleaner to power.
7. Set the On/Off switch to On (l) position and resume vacuuming.

MAINTENANCE AND CLEANING

Do not remove the filter cage. It is there to help prevent your fingers from
getting into the blower wheel.
Always unplug the wet/dry vacuum before removing the powerhead from the tank.
Make sure the vacuum is unplugged from the power source.
Disconnect the hose from the tank.
Undo the latches and remove the powerhead from the tank.
Remove any dirt or debris from the tank and hose.
Check the hoses, attachments and the power cable for any damage.
Clean exterior and interior of the vacuum using a slightly damp cloth. Do not use
any harsh chemical to clean the vacuum.

INSTALLING FILTER

To reduce the risk of injury from accidental starting,
unplug power cord before changing or cleaning the filter.
This filter is made of high quality paper designed to stop
small particles of dust. The filter should be used for dry pickup. A dry filter is
necessary to pick up dust as when the filter is wet the filter will clog quickly and
be difficult to clean.
15
1. Verify that the power cord is disconnected from the outlet.
2. Remove powerhead and place in upside down
position.
3. Install the cartridge filter over the filter cage with the
flat end of the filter towards the vacuum powerhead.
Carefully push filter in until it stops against the pow-
erhead.
4. Place filter cap on top of cartridge filter over the
raised lip and tighten down by turning
cap clockwise, do not overtighten.

REMOVING AND CLEANING FILTER

1. Verify that the power cord is disconnected from the outlet.
2. Remove powerhead and place in upside down position.
3. Unlock and remove the filter cap by tuning cap handle counterclockwise.
4. Carefully hold and pull the cartridge filter up for removal.
5. Clean the cartridge filter by gently tapping or brushing dirt off. Cleaning should
not be done indoors in living areas. For optimal performance, a new filter is rec-
ommended.
6. Install cleaned or new filter into place as instructed above in steps 2 and 4 of
Installing Cartridge Filter.
7. Wet filters should be removed and allowed to air dry for 24 hours before
installing onto the filter cage.

TROUBLESHOOTING

You must change the dust collection filter regularly. If
the vacuum is used without a collection filter bag, the motor will burn out
and your warranty will be invalid. Always keep extra collection filter bags
on hand.
FILTER
CAP
CARTRIDGE
FILTER
16