Manual Installation Of Software Drivers; Connecting Greenlee Devices To Your Pc - Greenlee Textron GVIS 300 Manual De Instrucciones

Manual Installation of Software Drivers

Before connecting your Greenlee devices to your PC, load the required drivers by following the instructions
below.
Installation of FTDI Chip Driver for the Greenlee GRP 460
Download the FTDI Chip driver at http://www.ftdichip.com/Drivers/CDM/CDM20824_Setup.exe.
Installation of UVC Driver for GVIS 400-HDP
No driver installation is required for the GVIS 400-HDP; it is included with Windows Vista, Windows 7, and 8.
Installation of Videology Driver for GVIS 300
Greenlee's GVIS 300 requires a Videology Windows driver for proper operation. If the serial number on the
GVIS 300 has a "C" appended to the end, navigate to the Videology/Windows 32-64-bit Cypress folder of the
installation package and double click on SetupVid and follow the installation instructions.
If there is no "C" after the serial number, then go to web page http://www.videologyinc.com/download.htm and
download the SFT-04040 Windows driver and follow the installation instructions.

Connecting Greenlee Devices to Your PC

GVIS 400-HDP
Connect the Greenlee GVIS 400-HDP cable to the PC's USB port. Wait for Windows to load the UVC driver. You
should see Windows report a message indicating the driver loaded successfully.
GVIS 300
Connect the Greenlee GVIS 300 to a USB port on your PC using the supplied USB cable. Wait for Windows
to load the driver you installed in the section above. You should see Windows report a message indicating the
Videology Camera driver loaded successfully.
GRP 460
Connect the Greenlee GRP 460 power meter to a USB port on your PC using the supplied USB cable. Wait for
Windows to load the driver you installed in the section above. You should see Windows report two messages
indicating the drivers loaded successfully.
Greenlee / A Textron Company
GVIS 300 • GVIS 400 • GPAD 250
10
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070