Polygroup SUMMER WAVES Manual Del Usuario página 13

OWNER'S MANUAL
4.1 If the pool is filled with water, unscrew the strainer grids from the strainer connector and insert the black hat like plug(s) into the inlet and outlet connectors, before
installing the salt water system to prevent excessive water drainage.
4.2 Disconnect the water return hose form the filter pump connection
4.3 Make sure a strainer grid piece 15 and connecting tube 13 are properly installed onto the electrolytic cell unit inlet, lock with hose clamp 14 securely.
4.4 If needed, connect the universal hose adaptor 28 to filter pump hose, tightly.
4.5 Remove the black hat like plug(s) from outlet that prevent water from flowing out of the pool if still inplace.
5. Connect the electrolytic cell unit outlet 24 .
5.1 Connect the 1.25"(38mm) hose to the electrolytic cell outlet 24 , and lock it with hose clamp securely.
5.3 Remove the black hat like plug(s) from inlet that prevent water from flowing out of the pool if still present.
5.4 Check the electrolytic cell unit 26 for water leakage.
6. Plug in the GFCI 27 to power on the salt water system.
Connecting the system to pump and pool
Inlet Outlet
SWIMMING POOL
FILTER/SKIMMER PUMP
16
26
24
27
FIG.1
FLOW SENSOR CLEANING
1. Unplug the power cord.
2. Remove outlet hose end, check inside the electrolytic cell outlet tube. Make sure it is dirt and clog free.
3. Move any debris or dirt if necessary.
FIG.2
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
MST. Extended operating days and hours during peak season requirements.
13