Step 1: Installation; Panel Mounting The Controller; Panel Cut-Out Sizes - ero electronic ELK Guía Del Usario

1.4. Step 1: Installation

This controller is intended for permanent
installation, for indoor use only, and enclosed in an
electrical panel
Select a location which is subject to minimum
vibrations and the ambient temperature is within 0
o o
and 55 C (32 - 131 F)
The controller can be mounted on a panel up to
15mm thick
To ensure IP65 and NEMA 4 front sealing against
dust and water, mount on a non-textured surface.
1.4.1.

Panel Mounting the Controller

1. Prepare a cut-out in the mounting panel to the
size shown. If a number of controllers are to be
mounted in the same panel observe the
minimum spacing shown.
2. Fit the IP65 sealing gasket behind the front
bezel of the controller
3. Insert the controller through the cut-out
4. Spring the panel retaining clips into place.
Secure the controller in position by holding it
level and pushing both retaining clips forward.
5. Peel off the protective cover from the display
Part number HA028438. Issue 3.0.
1.4.2.
.
Oct-05

Panel Cut-out Sizes

45 mm
- 0.0 + 0.6
1.77 inch
-0.00, +0.02
45 mm - 0.0 + 0.6
1.77 inch -0.00, +0.02
92 mm
- 0.0 + 0.8
3.62 inch
-
0.00, +0.03
Model ELK
Model ETK
7