Joneca ASD-1250 Manual De Instrucciones página 4

INSTALLATION OF MOUNTING ASSEMBLY (CONTINUED)
1
c. Be sure the sink is clean. Load the underside rim of the sink flange
with plumber's putty (1). From top of the sink, push the sink flange
down against the sink opening to make a good seal (2). DO NOT
MOVE OR ROTATE the sink flange once it has been seated or the
seal may be broken.
d. Place a heavy object, such as the disposer (use a towel
to prevent sink scratching) on top of the Sink Flange to
hold it down.
e. Take the remaining portion of the mount assembly, that was put aside.
From under the sink insert the Fiber Gasket (3), then the Support Flange
(4), and then the Upper Mount Ring (5).
f. Hold the three parts in place while attaching the Retainer Ring (6) by
pulling it apart and having it snap within the groove of the sink flange (7).
g. Tighten the three Mount Screws evenly and firmly against the Support
Flange (8). Do not over tighten.
h. Trim off any excess plumber's putty.
i. Attach disposer onto the Upper Mount Ring by aligning the three mount
tabs on the Lower Mount Ring with the slide-up Ramps on the Upper
Mount Ring and rotating counter clockwise. See Below.
B
The lower mounting ring (which is part of
the disposer) has 3 tabs that grab the
mounting ring ramp.
(A) points to the Upper Mount Ring.
(B) is the tab that slides up onto the
"Ramp".
(C) is the "Ear" that is used to help rotate
the Lower Mount Ring.
3
4
2
5
A
D
C
Lift and turn the Lower Mount
Ring counter clockwise until all
three mount tabs lock over the
Ridges (F) on the slide-up Ramps
(D) of the Upper Mount Ring.
Sink
As the Lower Mount Ring is turned counter clockwise
each tab slides up onto the Upper Mount Ring Ramp (E)
and locks in position over the Ridges (F).
Use a screwdriver or hammer for leverage if needed.
If a disposer needs to be removed, tapping on the Ear
clockwise with a hammer will easily loosen the Lower
Mount Ring.
4
6
7
Removable Splash Guard
Sink Flange
Plumber's Putty (not included)
Groove
Fiber Gasket
Support Flange
Upper Mount Ring
Retainer Ring
Cushion Ring
Lower Mount Ring
Rubber Gasket
Elbow Flange & Screw Set
Elbow
Reset Button
E
8
F