Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Assembly & Set-Up
Contents of Carton
•
One Tiller
•
One Operator's Manual
Assembly
References to the right and left side of tiller are determined from
behind the equipment in the operating position.
Recommended Tools for Assembly
•
One 1⁄2" open-end wrench
•
One 3⁄8" open-end wrench
•
Clean oil funnel
•
Motor oil. Refer to the Engine Operator's Manual for oil
specifications and quantity required.
Handle
1.
Identify the forward clutch cable. See Figure 1-1.
Forward Clutch Cable
Figure 1-1
NOTE: Be sure not to kink cables while attaching.
•
One Handlebar Assembly
•
One Engine Operator's Manual
2.
Hook the "Z" end of the forward clutch cable into the tine
engagement lever Figure 1-2.
3.
Remove the hex screw and bell washer from the right side of
the frame. Hold the cable guide bracket on the left side of frame
as it will fall when the bolt is removed. Step 1 in Figure 1-3.
1
Cable Guide
Bracket
4.
Insert the handle into tiller frame as shown. Step 2 in Figure 1-3.
5.
Insert the bolt through the cupped washer, frame, handle
and into the cable guide bracket (note the notch in the
cable guide bracket goes over the flange on the frame.)
Step 3 in Figure 1-3.
•
One Depth Gage Assembly
Figure 1-2
Hex Screw
Bell Washer
Handle
2
Bell Washer
Figure 1-3
3
Hex Screw
3
7
Tabla de contenido
Solución de problemas
