miniland baby super 3 deco Manual Del Usuario página 7

OPERATING INSTRUCTIONS
Bottle Warming:
1. You can use the steaming part to warm a bottle.
2. Take out the small lid of the steaming part. Place the bottle on the steaming bowl.
3. For standard bottle, let the adaptor ring on the cover for better warming.
For wide neck bottle, please take out the adaptor ring.
4. Add water into the steel bowl of the console by the measuring cup.
Please refer to the table below for the water amount for different bottles:
From fridge temp
From room temp
5. Final temperature of bottle content may vary due to different room temperature, size of bottles or
shape of bottle. If you found the temperature of the bottle content is too low, you can add more
water next time. If it is too hot, add less water.
6. Plug the appliance into the power supply socket.
7. Press the start button to begin the warming cycle.
8. The indicator light and the heater will turn off automatically when the warming cycle is complete.
9. WARNING: To avoid burning your baby, test the temperature of the bottle content, by dropping a
few drops on the back of your hand, every time before you feed the baby.
Bottle Sterilization:
Before placing items in the appliance for sterilization it is important that all bottles, teats and
accessories are empty and that they are cleaned and fully rinsed in fresh water.
1. Place the sterilizer on a flat surface where it is out of reach of children and it will not be knocked
or moved during operation.
2. Remove the container and lid from the sterilizer pedestal.
3. Remove the lid and place the rinsed bottles with their opening facing downward in the bottle rack.
4. Lay teats and other accessories in the accessory rack with their opening facing downwards.
5. Replace the lid.
6. Remove the measuring cup from the control console and fill it with an approximate 90ml of fresh
water and pour it into the steel bowl.
240ml bottle
21 ml
17 ml
330ml bottle
24 ml
20 ml