Installing The Carousel; Removing The Carousel - Rimage Producer 7100 Manual Del Usuario

Installing the carousel

Tip: To prevent errors, install the carousel before operating the software or powering on the
autoloader.
1. Open the front door.
2. Install the carousel in the Producer III autoloader.
a. Slide the carousel straight in so that the center post slides through the slot opening of
the bearing guide.
b. To seat the carousel securely, rotate the carousel until the top support bearing lowers
into the bearing guide.
3. Close the front door.

Removing the carousel

Tip: You can remove the carousel from the autoloader to load or unload discs.
Important! If software is currently running an operation on the autoloa
software to complete th
1. Open the front door.
2. Grasp the bottom of the carousel with two hands and
until the top support bearing clears the bearing guide.
3. Move the carousel outward and away from the autoloader.
110867_A
Bearing Guide
e operation, or pause the software operation.
Operate the Producer III autoloader
Top Support Bearing
Center Post
der, wait for the
lift the carousel off the carousel platter
7