Reset Button; Technical Features - Fermax LYNX Manual De Instalador

L L L L L YNX R YNX R YNX ROUTER YNX R OUTER OUTER OUTER
YNX R OUTER
L L L L L YNX R YNX R YNX R OUTER OUTER
YNX R YNX ROUTER OUTER OUTER
• Status LEDs: Status LEDs are all turned on by the BIOS on power up. The BIOS will turn
off LED 2 before booting the operating system. The left and right leds blink in green
when the status is ok. The middle led is only on when rebooting the system.
o CPU: Shows CPU activity.
o HDD: Shows HDD activity
o NET: Shows netword
• Reset the system to defaults. The reset button must remain

• RESET BUTTON:

pressed for ten seconds. Then you have to wait until the lights go out completely
and the lights turn back on.

9. TECHNICAL FEATURES

System board specs:
• CPU: 500 MHz AMD Geode LX800.
• DRAM: 256 MB DDR DRAM.
•
Storage: CompactFlash socket, 44 pin IDE header
• Power: DC jack or passive POE, min. 7V to max. 20V
• Three front panel LEDs, pushbutton
• Expansion: 2 miniPCI slots, LPC bus
• Connectivity: 2 Ethernet channels (Via VT6105M 10/100)
• I/O: DB9 serial port, dual USB port
• Board size: 6 x 6" (152.4 x 152.4 mm) - same as WRAP.1E
• Firmware: tinyBIOS
activity.
Pag 11